|
|
|  | |
| | |
| |
 | |
Pin Vise
Hand tool that uses the collet system to grasp and hold bits much the same way a Dremel or Flexible Shaft Machine would, but allows for a more delicate use of the bit that is inserted.
In the FOS kit, the pin vise is used to hold the tap, or threader (see below).
|
|
|
| |
|
| | |
| |
 | |
Tap
Also known more familiarly as a "threader", a tap will put thread on the interior of a hole.
The hole for the tap must be slightly smaller than the tap itself.
The FOS kit uses an 0-80 tap, meaning that it will cut 80 threads per inch inside of a #55 drill hole. This matches the 0-80 miniature bolts that will thread into these "tapped", threaded holes.
It should be mounted in pin vise for optimum control (see above).
|
|
|
| |
|
| | |
| | Page 4 of 4 | | | [1] [2] [3] [4] |
|
|
|
